Electrical Engineering test questions for exams and entrance - 1
(1) The statement that is not true for a continuous time causal and stable LTI system is
(A) Zeros of the system can lie anywhere in the s-plane
(B) All the poles must lie within | s | = 1.
(C) All the poles of the system must lie on the left side of the j? axis.
(D) All the roots of the characteristic equation must be located on the left side of the jω axis
View Answer / Hide Answer
(2) Let v = 2x²y + 3y²z + 4z²x. The curl of the gradient of the scalar field v is
(A) 0
(B) ∞
(C) 4ax + 6ay + 8az
(D) None of the above
View Answer / Hide Answer
(3) On which factor the slip of an induction motor normally does not depend?
(A) Shaft torque
(B) Rotor speed
(C) Core loss component
(D) Synchronous speed
View Answer / Hide Answer
(4) For finding mutual inductance the bridge method that is commonly used is
(A) Schering bridge
(B) Heaviside Campbell bridge
(C) Wein bridge
(D) De sauty bridge
View Answer / Hide Answer
(5) Which one of the following statement is true for a 4-point starter? A 4-point starter is used to start and control the speed of a
(A) Dc compound motor
(B) Dc series motor
(C) Dc shunt motor with field weakening control
(D) Dc shunt motor with armature resistance control
View Answer / Hide Answer
(6) The low-pass filter and high-pass filter are cascaded with each other. Cut-off frequency of low-pass filter and high-pass filter are 30Hz and 20 Hz respectively. The resultant system
of filters will function as
(A) An all-stop filter
(B) An all-pass filter
(C) A band-pass filter
(D) A band-stop filter
View Answer / Hide Answer
(7) For the periodic waveform given below, the second harmonic component has amplitude of
(A) 1
(B) 0
(C) 2/π
(D) √5
View Answer / Hide Answer
(8) Consider the figure given below. A source has a load line v + i = 100.The current through the resistance is
(A) 150 A
(B) 100 A
(C) 50 A
(D) 25 A
View Answer / Hide Answer
ANSWER: 50 A
(9) The base load power plants are
(A) Nuclear, run-of-river and diesel
(B) Nuclear and run-of-river
(C) Run-of-river and pump storage
(D) Pump storage and diesel
View Answer / Hide Answer
(10) Consider a transmission line that has a sending end voltage V. For a fixed value of complex power flow in such a transmission line, the real power loss will be proportional to
(A) 1/V²
(B) V
(C) V²
(D) 1/V
View Answer / Hide Answer
(11) Let Q be a (5 x 6) matrix. The rank of Q is 4. The statement, which holds correct for Q, is
(A) Qt Q will be invertible
(B) Q Q t will be invertible
(C) Q will have four linearly independent rows and five linearly independent columns
(D) Q will have four linearly independent rows and four linearly independent columns.
View Answer / Hide Answer
(12) Let uniformly distributed random variable be X. X takes the values between 0 and 1. The value of E {X³} will be
(A) 0
(B) 1
(C) 1/2
(D) 1/4
View Answer / Hide Answer
(13) The firing angle of a single-phase fully controlled thyristor bridge ac-dc converter is 25 and an overlap angle is 10. The constant dc output current is 20 A. The fundamental power
factor (displacement factor) at input ac mains is
(A) 0.8
(B) 0.78
(C) 0.9
(D) 1.2
View Answer / Hide Answer
(14) The system shown below is
(A) Stable for input u1 but unstable for input u2
(B) Conditionally stable
(C) Unstable
(D) Stable
View Answer / Hide Answer
(15) An electrically short, medium and long line primarily depends on the
(A) Power transmitted over the line
(B) Nominal voltage of the line
(C) Physical length of the line
(D) Wavelength of the line
View Answer / Hide Answer
(16) Considering the cost and overall effectiveness, the circuit breaker that is best suited for capacitor bank switching is
(A) Air blast
(B) Vacuum
(C) SF6
(D) Oil
View Answer / Hide Answer
(17) For the voltage u (t) = 3 + 4cos(3t), the RMS value is
(A) √17 V
(B) 3 V
(C) 4 V
(D) (3 + 2√2) V
View Answer / Hide Answer
(18) Which one of the following statement holds true for High voltage dc transmission line? HVDC transmission is mainly used for
(A) Minimizing harmonics at the converter stations.
(B) Eliminating reactive power requirement in the operation.
(C) Interconnecting two systems with the same nominal frequency.
(D) Bulk power transmission over very long distances.
View Answer / Hide Answer
(19) Consider a long solenoid of length 1000mm.It is wound uniformly with 3000 turns on a cylindrical paper tube of 60 mm diameter. The inductance of solenoid is
(A) 3.2 μH
(B) 0.32 mH
(C) 32.0 mH
(D) 3.2 mH
View Answer / Hide Answer
(20) _____________ has the highest power factor at full load
(A) Shaded pole type of single-phase induction motor
(B) Capacitor-run type of single-phase induction motor
(C) Capacitor-start type of single-phase induction motor
(D) Split phase type of single-phase induction motor
View Answer / Hide Answer
(21) Figure shows the waveform of the current passing through an inductor. Inductor has resistance of 1 ohm and inductance 2H. The energy absorbed by the inductor in the first four seconds
is
(A) 168J
(B) 100J
(C) 98J
(D) 144J
View Answer / Hide Answer
(22) Consider a single-phase transformer. Maximum efficiency of transformer is 90% at full load and unity power factor. What will be the efficiency at half load at same power factor?
(A) 87.8 %
(B) 88.9%
(C) 89.6%
(D) 98.2%
View Answer / Hide Answer
(23) Consider a passive steady state 2-port network. Compared to its input, the steady state output can never offer
(A) Better regulation
(B) Greater power
(C) Lower impedance
(D) Higher voltage
View Answer / Hide Answer
(24) If two incandescent light bulbs of 40 W and 60 W rating are connected in series across mains then
(A) The bulbs together consumes 50 W
(B) The bulbs together consumes 100 W
(C) The 40 W bulb glows brighter
(D) The 60 W bulb glows brighter
View Answer / Hide Answer
(25) It is desirable to eliminate 5th harmonic voltage from the phase voltage on an alternator. The coils should be short-pitched by an electrical angle of
(A) 63°
(B) 72°
(C) 30°
(D) 36°
No comments:
Post a Comment